Incorporated in the year 1981, we are noted as one of the well-known & reckoned manufacturers and exporters of Power Distribution Transformer. Our entire range of transformers is manufactured at our well equipped manufacturing unit using tested quality components & materials. Widely used for distribution of electrical energy, these transformers are offered to clients without any delay. Before final dispatch, our Power Distribution Transformer is rigorously inspected on certain quality parameters.
- Ease of installation & maintenance
- Perfect design & construction
- Good efficiency & performance
We are providing Power Distribution Transformer and Voltage Power Transformer that are manufactured with customers' requirement and standard rating. Also, our transformers are designed & tested according to IS2026.
Range of Distribution & Power Transformer:
- High coupling capacitance value
- Maximum magnetic field leakage
- Leakage current
- Static electric noise transformers
Transformer Design Options:
- Indoor / Outdoor
- Single Phase / Three Phase
- Ground Mounted / Pole Mounted
- Hermetically Sealed Transformers / Conventional Type
- Corrugated Radiator / Conventional Radiator
- Copper / Aluminum Wound
- Fitting Accessories, as per requirements.
Core: Core is engineered from imported high-grade cold rolled grain oriented silicon steel lamination. The Lamination cut at an angle of 45 degree Celsius. Mitered / Interleaved joints reduce the losses of core & magnetizing current. The core is clinched with steel channel stiffly to cut down the level of cartile sound.
Winding: Windings are designed to perfect the dynamic, thermal mechanical & electrical strives depending on the voltage/current requirement. The coils are wound with high conductivity electrolytic grade annealed wire & stripe, covered with top grade insulation. Cooling ducts are given between the windings & oil in order to decrease hot spot temperature and the temp. gradient.
Insulation & Oil: Insulation material like pre-compressed board, tube, bakelite, insulating top, epoxy/porcelains bushing, varnish, etc. are utilized for top quality and to assure long life of the transformers. Used as a coolant the Oil conforms IS 335, is filtered & centrifuged before filling into the transformer to guarantee free from moisture & dust.
Tanks & Radiator: All the tanks are built by cold/hot rolled steel plates by welding. They are outfitted with corrugated steel radiator sheets, in conformity with the capacity.
Paint: Exterior & interior surface are chemically cleaned & coated with red oxide, and two final paint coat outside of tank body for long & better life.
Temperature Rise: Engineered for maximum temperature rise, at fully rated load, 40 to 50 degree Celsius for aluminum wound, and 45 to 55 degree Celsius for copper wound transform.
E-641, Phase VII, Focal Point, Ludhiana, Punjab, 141010, India